Ford Mustang GT 15-17 OEM Engine

This is a used OEM 5.0L V8 "Coyote" long block pulled from a 2015-2017 Ford Mustang GT, a naturally aspirated DOHC 32-valve engine (4951cc) rated by the factory at roughly 435 HP and 400 lb-ft of torque, identified by the F code in the eighth VIN digit. It suits GT owners rebuilding a tired motor or swapping a genuine factory block into a project car. What you get The package centers on the long block itself: block, cylinder heads, and internal rotating components. Intake and exhaust manifolds come along where applicable, along with the coil packs and valve covers. The alternator, starter, ECU, and wiring harness aren't part of this package unless a particular unit says otherwise, so budget for sourcing those from a donor car or the aftermarket if your swap needs them. Before you buy Because this is a used engine pulled from a running vehicle, mileage will be on the lower side for the platform but is not published here; confirm exact mileage with us before ordering. The motor has been compression tested and inspected, then cleaned and sealed for transport. Since it ships as used OEM hardware rather than new or remanufactured, expect normal wear consistent with a running pull, not a fresh-build finish. Common questions Will this bolt into any Mustang GT? It is pulled from and intended for the 2015-2017 GT, so check your model year and accessory layout before ordering. Does it include the transmission? No, this listing covers the engine long block and the components noted above only. Is it new or used? Used OEM, removed from a donor vehicle and tested rather than rebuilt from scratch.