Chevrolet 350 Chevy Crate Motor

A 350 cubic inch small block Chevy crate motor rated at approximately 450 horsepower, assembled as a turnkey roller engine with a roller camshaft and an A/C-ready accessory drive for a street and strip build. What it is built for This engine is aimed at builders who want a plug-and-play small block rather than a bare block to assemble themselves. The internals include a forged crankshaft and forged rods with performance pistons, paired with aluminum high-flow cylinder heads, a roller cam, and a performance intake, with either an EFI or carbureted fuel setup available. What to check before ordering Verify your mounts, driveline, and cooling system have the capacity for an SBC-based build before buying, since fitment is not universal across every classic or custom Chevy chassis. The listed power range runs from roughly 1,500 to 6,500 rpm, with a 2,000 stall converter recommended for drivability, and the engine is described as streetable with enough vacuum signal for accessories. Short-block, long-block, and full turnkey configurations are available, and transmission packages such as the TH350, 700R4, or 4L60E can be paired with it. Common questions Is this engine fully assembled? Yes, it is described as a turnkey, dyno-tuned motor ready for installation. Does it include A/C provisions? Yes, the accessory drive is built to be A/C ready, along with an alternator and power steering provision. Is a transmission included? No, but transmission packages are offered separately to pair with the engine.