Auto Metal Direct AMD 351-1067 Lower Radiator Support, 1967-76 Dodge & Plymouth A-Body

AMD's 351-1067 reproduces the lower section of the radiator support on 1967-1976 Dodge and Plymouth A-Body cars, the part of the support AMD says is most often bent or distorted by the time these cars need restoration work. As shipped the panel is sized at 43 inches in length, 10 inches in width and 10 inches in height, with a shipping weight of 10 lbs. Check your model against the fitment range This listing spans a wide set of A-Body cars built over roughly a decade: the 1971-1976 Plymouth Scamp, 1971-1972 Dodge Demon, 1967-1976 Plymouth Valiant, 1970-1976 Plymouth Duster, 1967-1976 Dodge Dart, 1967-1969 Plymouth Barracuda and 1973-1976 Dodge Dart Sport. Because support design changed across that long production run, match your car's exact model and year to this list rather than assuming any A-Body support will do. Why this lower piece specifically Radiator supports on these cars tend to collect road salt and moisture low down, near the ground, which is why the bottom section fails first even when the upper structure is still sound. Replacing just this lower piece, rather than the whole assembly, is usually enough when damage is limited to that area. Common questions Does this replace the entire radiator support? No, it reproduces the bottom portion only, the section identified as typically bending or rusting first. How much does it weigh for shipping purposes? 10 lbs as listed.