ATK Engines ATK HP36C-EFI Chevy 383 with Fitech EFI 435HP

The ATK HP36C-EFI swaps a carburetor for a Fitech Go EFI 4 600HP throttle-body kit on the same 435-hp, 475-lb-ft 383 stroker platform ATK sells with a carburetor; AFR's aluminum heads return here too, 72cc chambers, valves at 2.02/1.60. Why choose EFI over the carbureted version Throttle-body injection generally tunes itself better across temperature and altitude swings than a fixed carburetor jet, and Fitech's handheld controller lets you adjust fuel curves without pulling the intake. Scat's forged rotating assembly, nodular-iron crank and I-beam rods, anchors this stroker's bottom end under forged pistons at 10:1 compression, and the Edelbrock dual-plane intake, distributor, water pump, and balancer all ship mounted alongside the EFI hardware. Planning your fuel system Fitech supplies the throttle body, wiring harness, and handheld unit, but not a fuel pump. Either an electric fuel pump or a mechanical pump run through Fitech's Fuel Command Center will work. Oil pan and timing cover ship installed; flexplate and flywheel are left to match your transmission. Common questions Can I use my existing carburetor instead? No, this version is set up specifically for the Fitech throttle body, not a carburetor. Do I need a separate fuel pump? Yes, this kit does not supply one; an electric unit works, and so does a mechanical pump routed through Fitech's Fuel Command Center setup. California requires BAR compliance for engine swap installations.